piece_two is an object designed to protect the head from sunlight and heat. Inspired by the opening mechanism of a fan, this headwear can be opened and closed in the same way. The shape of the headpiece allows air to circulate, which provides an additional cooling effect. The pattern is customizable to the individual head circumference, so it’s best to measure before starting the crafting process.

For the piece_two, you’ll need a thick and sturdy fabric. Alternatively, you can also use a thinner fabric that is ironable. You should reinforce this thinner fabric (Tip: Vlieseline S520 or Decovil I). For the closure, you’ll need a band that is a maximum of 1.5cm wide. It should be very stiff. You can use a grosgrain ribbon for this or a faux leather band. To make these bands even more stable, you can reinforce them with a corset band. In addition, you’ll need a closure system. For this, you can use snap buttons or alternatively a Velcro closure.

The color of your fabric should be light, as this allows sunlight to be well reflected. So, you can choose a white, light gray, silver, or pale gray fabric for this purpose.

sewing instructions

information

Tools you will need for piece_two: printer, tape, sewing accessories, ruler and compass or transfer foil and sublimate pen

Materials required: fabric piece 70×70 cm, press studs or another method of closing the piece, sturdy ribbon or corset ribbon and some fabric from the piece fabric to tie it in

instructions

Tape the pattern together to form a circle with a radius of 35cm.

Cut out this circle and place it on the desired fabric. If you are using interfacing, cut the circle out of interfacing first. Then, iron the interfacing onto the desired fabric before cutting out the final shape. If using Vlieseline S520, iron it with a damp cloth for 15 seconds at each spot.

Now, transfer the 12-degree divisions of the pattern onto the fabric (use transfer paper or a similar method) or use the small circle included with the pattern. Place it in the center of the fabric circle (underside of the fabric). Now, you can continuously mark the lines on the fabric. Remove the helper circle and extend these lines towards the center. You should now have a 35cm radius circle divided into 30 segments, each with 12 degrees. Use a compass or the pattern to draw a circle with a radius of 11.5 cm on the back of the fabric. Now, draw a second circle with a radius of 14.5 cm.

The next step is to cut openings for the band. Use a rotary cutter or a utility knife. If your fabric frays, sew a seam around the cuts. Also, choose one of the lines, cut it towards the center, as this will be the opening of the hat.

Now, stitch along the previously marked lines to be able to fold the edges accurately.

It’s best to sew beyond the center, sewing the opposite seam simultaneously.

Now, introduce the folds into the fabric to place the darts in the right position. Place the fabric with the inside of the hat facing up. Start by folding the segment at the hat’s opening upward. Now fold one pleat after another, as you would with an accordion.

Once done, sew the darts at the respective edges so that the folds maintain their shape. Depending on the fabric used, you may need to sew darts both in the back and front. If using interfacing, it may be enough to sew only the outer tips.

Now, insert and trim your band to the desired length.

The final step is to attach the closure, preferably snap buttons. Ideally, use at least two buttons for the hat and one for the headband.